|
RADOLID
PROTECTION CAPS
Radolid
Protection Caps will ensure proper bolting, even after years of
exposure to the elements!
At
left is an example of bolted joints with Radolid
Protection Caps (one cap cut open) and without protection caps.
After a five-year test, the effects of atmospheric corrosion is very
damaging and therefore costly.
Radolid
Protection Caps are easily installed by pressing the cap onto the
bolted joint by hand. The barbed edge snaps on and prevents the
caps from accidental removal. Radolid
Caps are reusable and can be re-applied to 2-3 times. To ensure against corrosion from condensation
accumulating in the caps, we recommend brushing nuts with Kleergel®
Corrosion Inhibitor.
Standard
Radolid
Protection
Caps are manufactured of low density black UV-resistant polyethylene
that withstands temperatures of -84 degrees F to +210 degrees F. They
are also resistant to water, brine, hydraulic fluid, diesel, greases,
gasoline, hydrochloric acid concentrate, sulphuric acid to 40%,
nitric acid to 40%, ammonia, and acetum. Further resistance properties
can be given upon request.
Standard
Radolid® Protective Caps are black, but
they are also available in clear, white,
red, grey, silver and other colors on request. The different
types manufactured include: Type (1) for standard nuts or bolts without
washers, Type (2) for a nut or bolt with washer, and an adjustable
telescopic two piece cap that can be produced in various lengths
(It is even able to fit check
nuts). Our caps are sized to fit heavy hex nuts only; they will not
fit finished nuts properly. Radolid
Protection Caps are manufactured in sizes to fit 1/4 inch to 3 3/4
inch diameter bolts or studs. High temperature material of Polyamid
A4H for use up to +430° F is available.
|
