skip to navigation | skip to content
home

RADOLID® PROTECTION CAPS

Radolid Cap
Radolid Cap
Radolid Cap

Radolid Protection Caps will ensure proper bolting, even after years of exposure to the elements!

At left is an example of bolted joints with Radolid Protection Caps (one cap cut open) and without protection caps. After a five-year test, the effects of atmospheric corrosion is very damaging and therefore costly.

Radolid Protection Caps are easily installed by pressing the cap onto the bolted joint by hand. The barbed edge snaps on and prevents the caps from accidental removal. Radolid Caps are reusable and can be reapplied to 2-3 times. To ensure against corrosion from condensation accumulating in the caps, we recommend brushing nuts with Kleergel Corrosion Inhibitor Grease.

Standard Radolid Protection Caps are manufactured of low density black UV-resistant polyethylene that withstands temperatures of -84 °F to +210 °F. They are also resistant to water, brine, hydraulic fluid, diesel, greases, gasoline, hydrochloric acid concentrate, sulphuric acid to 40%, nitric acid to 40%, ammonia, and acetum. Further resistance properties can be given upon request.

Standard Radolid Protective Caps are black, but they are also available in clear, white, red, grey, silver and other colors on request. The different types manufactured include: Type (1) for standard nuts or bolts without washers, Type (2) for a nut or bolt with washer, and an adjustable telescopic two piece cap that can be produced in various lengths (It is even able to fit check nuts). Our caps are sized to fit heavy hex nuts only; they will not fit finished nuts properly. Radolid Protection Caps are manufactured in sizes to fit 1/4 inch to 3 3/4 inch diameter bolts or studs. High temperature material of Polyamid A4H for use up to +430 °F is available.

made in the usa